
ECU system only, no harness
Characteristics
- OTTO cycle engine control up to 16 cylinders
- Wankel engines control up to 6 rotors
- 3 modes of fuel control (sequential, semi sequential and multi-point/batch fire)
- 2 modes of ignition control (wasted spark, sequential and distributor)
- Injection control by volumetric efficiency (VE)
- Electronic throttle body Control (Drive-By-Wire)
- 3 modes idle speed control (by PWM valve, by electronic throttle, by stepper motor and ignition timing)
- Closed loop injection through oxygen sensor (wide band lambda sensor)
- Real time programmable by dashboard, smartphone, tablet or VisionFT software
- 2 inputs dedicated for Crank and CAM signal
- 26 inputs channels totally configurable - digital and analog (2 high sensitivity inputs designed for strain gauge shifter)
- 8 input channels high speed (pink)*
- Accelerometer, gyroscope and GPS (integrated)
- 103psi internal MAP sensor (7 bar - absolute), 14.7psi of vacuum and 88psi of positive pressure (boost)
- 2 USB Type-C ports, one on the front and one on the back
- Communication port with automotive Ethernet- 4 CANs, (3-CAN FD)
- 50 configurable outputs separated by colors (16 blue'), (12 gray?) and (22 yellow35)
- 4 multimedia outputs (audio and video)
- Sequential injection control for up to 3 banks (A, B and C)
- Main injection map by MAP or TPS by RPM (3D) with injection time resolution of 0.001 ms
- Fuel enrichment and decay adjust, Individual cylinder trim setting by MAP or RPM
- Sequential ignition control for up to 16 cylinders (12 gray outputs + 4 yellow outputs)
- Main ignition map by MAP or TPS by RPM (3D) with ignition angle resolution of 0.1°
- Ignition timing compensation by (air temperature, engine, gear and gear changes)
- Many warning parameters such as: rev limiter, fuel cut-off, ignition cut-off, shift light on the screen and externally, audible signals, among others
- Dashboard with customizable instrument panel with gauges of different sizes and styles that can be used with any sensor present on the VCU
- Upper bar with 12 RGB LEDs to display RPM with configurable colors and values
- 8 RGB LEDs side lights which can be triggered by 3 different combined settings
- Diagnosis dashboard with real-time information of all inputs outputs, CAN and Status Events
- 1024 log recording channels
- 64 GB of internal memory
- 1kHz recording rate
- 617 hours of datalogger memory®
- Recommended for high impedance injectors without the need for an external driver (up to 4 injectors per output)
- Recommended for ignition (open collector outputs with 5V power supply)
- Recommended for driving stepper motors, electronic throttles, ignition and 12V loads.
- Used for high-speed sensors (400khz per channel)
5 - The green outouts. when not used to power the integrated Lambda Sensor, can be used as vellow outouts
6 - Recording time measured on the FT700 with 24 channels and 25Hz.
